The PixController Long Range Wireless RF (Radio Frequency) PIR Motion Sensor can be used with the entire PixController RF wireless product line including but not limited to the UndercoverEye series, DVREye RF wireless, and DigitalEye RF wireless products.

By removing the PIR motion sensor from within the recording device this will allow for more covert, larger PIR area of detection using several wireless RF motion sensor, and allow several different types of recording devices used in one setup.

This small wireless PIR motion sensor sends a digital RF signal back to the camera unit for triggering recording. The recording unit "listens" for wireless commands sent from the wireless PIR motion sensor when the motion sensor is tripped. When the recording unit receives a trigger event it will trigger the attached camera system to take a photo or record video.

The wireless RF motion sensor is powered by two small AAA batteries. These batteries will which will last for a year of continuous use. Since the sensor is on all of the time these batteries should be removed for storage.

There are (8) different digital addresses the wireless RF motion sensor can be programmed to send (addresses A – H). By changing the address this gives the user the ability to configure several sensors or recording units within range of each other to respond for a given setup.

There is no limit to the number of wireless RF motion sensor that can be used it a given setup. Several different types of recording systems can respond to one or more wireless RF motion sensors..

To mount the Wireless PIR motion sensor first remove the battery door and remove the AAA batteries. You will see 2 screw holes in which you can mount a small mounting plate or screw it to the surface of the mounting area. For best detection keep the sensors at 2’ to 3’ from the ground if you want to get the best detection of targets on the ground.

The range of the PIR detection is 40’ to 80’ depending on air temperature and temperature of the target. The hotter the target the longer detection range you will have. For example a car can be seen at a greater distance.

The RF wireless range back to the recording unit is about 50’ to 100’ depending on line of sight and terrain.
 

System Specs

Size: 2 ½” wide X 2 ½” tall
Detection Type: PIR (body heat & motion)
Detection Range: 50 feet at 70 deg F
Detection Area: 5 deg. Conical area
RF Frequency: 310 MHz
RF Range: 50 to 100 feet depending on terrain
Power: (2) AAA lasting 1 year
Addressing: Digital addressing up to 8 different addresses