User DIP Switch
The User DIP switch is where you setup the delay between photos (PIR Delay), day/night/24hr. photo taking, still or movie mode, camera power up delays, turning on/off the LED's, and much more. With a simple flick of a switch you can easily adjust these settings, and since the DIP switch is a right angle mounted switch it can be easily accessed if the board is front or back mounted. A front mounted board is a board you mount to the bottom of the case, and a back mounted board is a board you mount to the lid of the case. 

You must re-boot your board when you change these settings, but when doing so you must let your controller stay powered down for about 30 seconds. If you boot up your controller too fast you will see the green LED start blinking. If you see this just turn the power off and let it sit for about 30 seconds before reapplying power.